Take 2 square cards – I have used 144 x 144 square but any size will do. Cut one of them an inch away from the fold.

Stick them together – adhere the inch strip behind the whole card

Cut 2 triangles from both ‘fronts’ The easiest way is to put the card into a trimmer and line up the 2 diagonals (top left and side and bottom right hand side and reverse)

Cover front 2 triangles with PP - I always ink the edges of mine before I stick them down TIP use the off cut triangle place under PP and use as a template – you can just see the edge of the cream triangle under the PP - I then marked 2 pencil lines and cut .

Stick 2 bottom edges I prefer double sided tape and you have your pocket.

From one of the off cut triangles make an strip about an inch wide and then cover with a slightly narrower piece of PP – cut your strip from the widest point as it needs to go across the card.

Stick to card and then tie ribbon all the way round card and knot – finish with a fancy brad/button or similar

Using the rectangle off cut – the piece you 1st cut off the card - make an insert – I rounded the corners on this makes it easier to pull in and out.

Make a ‘tab’ cut some PP 2 inches square and fold in ½ and round corners whilst PP is double

Stick to rectangle and then cover with PP this then hides the edge. My PP was put through a cuttle bug embossing folder no need though!! ONLY stick one side of TAB down. 

Use a pokey tool and adhere fancy brads to the tab and then stick flap of tab down to cover the backs

Here are the two parts finished.