Free Downloads - Craft Robo GSD files - Christmas decoration box

This is just a box template that I have made - but have used it to make a Christmas decoration. The crease lines are a different colour so you can choose whether to have them perforated or not cut at all.  Go to --> Output settings --> cutting settings tab --> cutline settings

I have also added a pdf file that you can print out and trace around, or cut out and colour.

Decorate it first and make a hole in the centre of the middle square and thread some cord through. At the time of writing this I still had silver and gold cord in the shop.  (the glued flap was then at the bottom of my decoration.

Then fold over all the creases, be careful to make them accurate to ensure that they will be nice and square. Then use glue or double sided tape, and seal it all up. You could put a mini gift inside, or sweets and presented on Christmas Day if you can part with them!. 

Don't forget you can make things bigger and smaller in the Craft Robo Software.

Christmas decoration box
GSD File here - smaller

GSD File here - larger

PDF File here - smaller

PDF File here - larger


 © Carolyn Woodruff October 2009